Setting Watering Start Times; Eliminating A Start Time; Setting The Run Times (Length Of Watering); Setting Days To Water - Hunter Smart Valve Controller Owner's Manual And Installation Instructions

Setting Watering Start Times

1. Push the button until the Start Times icon
displayed.
2. Use the or button to change the start time. (The
start times advance in 15 minute increments) Hold either
button down for 1 second to change times rapidly.
3. Press the button to select the next start time (up to 9
start times are available).

Eliminating a Start Time

With the display in the watering Start Time mode, push the
or button until you reach 12:00 AM (midnight). From
here push the button once to reach the OFF position.
NOTE: If the SVC has all 9 start times turned
off, then the controller is off.
Setting the Run Time (Length of Watering)
1. Press the button until the Run Time icon
played.
2. The display will show the last run time entered.
3. Use the
on the display from 1 minute to 4 hours.
is

Setting Days to Water

1. Push the
displayed.
2. The controller will display seven days of the week with a
icon or a
would represent an "On" water day, while the
would represent an "Off" watering day.
Selecting Specifi c Days of the Week to Water
1. With the
starts with 1), press the
lar day of the week to water. Press the
cancel watering for that day. After pressing a button the
cursor automatically advances to the next day.
2. Repeat step 1 until all desired days have been selected.
The selected days will show with a
is dis-
status ON. The last
program.
or button to change the station run time
button until the Water Days icon
icon above the numbered day. The
cursor on a specific day (the cursor always
button to activate a particu-
is the last watering day for the
is
icon
icon
button to
to indicate their
7