Hunter NODE-100 Owners Manual And Programming Instructions page 15

BATTERY-LIFE INDICATOR
The remaining battery life can be estimated from the battery-life
indicator shown on the display . The NODE can operate using either
a single nine-volt battery or using two nine-volt batteries . Using two
nine-volt batteries will yield approximately twice the battery life of a
single nine-volt battery . The battery-life indicator chart below shows
an estimate on the remaining battery life .
Full: 100–60% remaining battery life
Med: 60–25% remaining battery life
Low: 25–0% remaining battery life
Replace battery immediately!
RESETTING CONTROLLER
Resetting the controller will erase the current program data and restart
the controller . A reset does not, however, delete a program saved to
permanent memory using the Easy Retrieve memory feature (see
page 12) to save a preferred program .
1 . From idle mode, press and hold the
2 . After two seconds the screen will go blank. Continue to hold
the , , and keys.
3 . 12:00 will flash on the display. Release the keys.
4 . The controller may show a countdown from 10 to 1 on the display,
and then 12:00 am will be shown flashing when the reset is
complete. The controller can now be reprogrammed.
EN
, , and keys.
14