5.
Gently push the opposite mounting bracket and lock
the axle into the hole on the mounting bracket.
Then straighten the mounting bracket to its original
position.
6.
Ensure that the mounting brackets are all straight
and that the stoppers on each mounting bracket are
in the correct position, preventing the blades from
over pivoting.
Repeat steps 3-6 for the second Winter Seal blade.
7.
Ensure that both blades pivot freely, and the orange
sticker is visible from underneath.
Then proceed with mounting the cooler refer to
sections:
"4.3 Fitting the KL Series Cooler" on page 10
"5.3 Fitting the KC Series Cooler" on page 11
13