Wall Controller Connection; Wiring The Kaden Networker Wall Control; Wiring The Kaden Manual Wall Control - Kaden KC17 Installer Manual

Kaden Installer's Manual
Evaporative Air Coolers

7. WALL CONTROLLER CONNECTION

7.1 WIRING THE KADEN NETWORKER WALL CONTROL

The Networker backing plate has 4 terminal points for the connection of Thermostat wires. When connecting, use
the top 2 terminal points marked TW1 and TW2 or the bottom 2 terminal points also marked TW1 or TW2. Never
use a combination of terminals when connecting to a single appliance.
For example; A Networker operating a cooler and a heater would have the 2 bottom terminals connected to the
heater and the 2 top terminals connected to the cooler.
Run a twin wire cable (i.e. figure 8 cable - 0.75mm²) from the Cooler to the Networker.
•
Remove the backing plate from the Networker by unclipping it at the sides.
•
Draw the wires from the wall cavity and feed them through the opening in the backing plate, connect the cable to
the terminal connections on the backing plate before mounting it on the wall and re-assembling the Networker.
•
Connect the cable to the Networker connection lead terminal block at the Cooler.

7.2 WIRING THE KADEN MANUAL WALL CONTROL

After the Cooler's power supply and pre-wired wall control leads are fed down from the base into the roof cavity,
connect the 20-metre wall control loom plug to the cooler's lead plug.
•
Ensure the wall control is positioned so that it is within reach of the cooler using the 20-metre wire loom assembly
supplied.
•
These Wall Controls accept the polarised plug connection.
The Manual wall control has a small loom to connect the polarised plug to.
All models can have either the Kaden Networker wall controller or the Kaden Manual wall
controller.
NOTE
14
Twin Wire
(figure 8, field supplied)
Networker Wall Controller
20 metre wall
control loom
Manual Wall Controller