Installation - Classic (Kc) Series; Kc Series Dropper Duct Installation Specific; Fitting The Winter-Seal; Fitting The Kc Series Cooler - Kaden KC17 Installer Manual

5. INSTALLATION - CLASSIC (KC) SERIES

5.1 KC SERIES DROPPER DUCT INSTALLATION SPECIFIC

•
All KC Series Coolers sit on a 550mm x 550mm dropper box with a 15-20mm out
turned flange.
•
KC Series Coolers can also be installed on an existing dropper box. Ensure the
dropper box is in a sound condition and the top of the dropper box is level.
•
The dropper box MUST BE positioned as per the following diagram.
•
Secure the dropper duct vertically, so the Cooler is level when placed on top of it.
•
Ensure the 3 pin power supply plug and lead, the Wall Control Loom connection
lead, and the rubber grommet, are fed to the inside of the dropper duct.
•
Cut a 43mm hole in the dropper duct below the roof line, on the left-hand-side on
the low side of the roof, to accept the wiring grommet. This will allow the 3-pin plug
and lead, and the Wall Control Loom connection lead to be withdrawn from the
dropper into the roof cavity.

5.2 FITTING THE WINTER-SEAL

The Winter Seal fits directly into the base of the cooler and MUST BE installed before the cooler
is mounted onto the dropper box (preferably while the unit is on the ground).
IMPORTANT
For detailed instructions please refer to "6. Fitting the Winter-Seal" on page 12.

5.3 FITTING THE KC SERIES COOLER

•
The Cooler should now be mounted into position. Insert the Cooler's air outlet fully into the dropper duct.
•
Ensure the Cooler base sits fully on the dropper box flange and that the base latching brackets (four) retract over
the flange on both sides of the dropper, to lock it onto the dropper duct.
•
Fold the end of all four latching brackets in towards the dropper box. Using the hole at the end of the latching
bracket as a guide, drill a 3mm pilot hole through the dropper box only. DO NOT penetrate the plastic chassis.
Four 8g x ½" stainless steel screws should be inserted to secure the four latching brackets to the dropper box.
•
The Cooler's smallest filter pad and the water supply connection fitting MUST BE on the high side of the roof.
•
Ensure the 3 pin power plug and lead, together with the Wall Control connection lead, are also fed to the inside
of the dropper duct before retracting the wires and fitting the grommet.
High side of roof
Cut hole in this position
using 43mm hole saw
below roof line to accept
wiring grommet in this
corner. (Closest to Cooler
Control Box)
11