Table of Contents
Advertisement
Wiring Diagram
This machine must be grounded. Replacement of the power supply cable should only
be done by a qualified electrician. See page 5 for additional electrical information.
(BLACK)
LIVE
(WHITE)
NUTRAL
(GREEN)
EARTH
This tool is intended for use on a circuit that has a 120 volt electrical receptacle.
The illustration on page 5 shows the type of the 120v, 3-wire electrical plug and
electrical receptacle that has a grounding conductor that is required.
SPINDLE ASSEMBLIES
Ready to install, includes the
threaded arbor, 4-1/2" rubber
cylinder, top washer and nut.
Fits 50-300 Spindle Sander only.
50-3012 1/2" Diameter
50-3034 3/4" Diameter
50-3001
1" Diameter
50-3112
1-1/2" Diameter
50-3002
2" Diameter
50-3003
3" Diameter
(3" is not included with machine)
Use this section to record maintenance, service and any calls to Technical Support:
WIRING DIAGRAM
NVR SWITCH
ACCESSORIES
50-45060 60 Grit Diameters 1/2", 3/4", 1" 1-1/2", 2" (PK 5)
50-45100 100 Grit Diameters 1/2", 3/4", 1" 1-1/2", 2" (PK 5)
50-45150 150 Grit Diameters 1/2", 3/4", 1" 1-1/2", 2" (PK 5)
50-45303 60, 100, 150 Grits Diameter 3" (Pack of 3)
NOTES
18
(BLACK)
MOTOR
(WHITE)
SANDING
SLEEVES
Resin bonded,
Aluminum Oxide
Abrasives, 4-1/2" long.
Packs of 5 or 3 as
listed below.
Advertisement
Table of Contents
