Maintenance; Wiring Diagram - Rikon Power Tools 50-144 Operator's Manual

Turn the power switch "OFF" and disconnect the plug from the outlet prior to
adjusting or maintaining the sander. DO NOT attempt to repair or maintain the electrical components
of the motor. Take the sander to a qualified service technician for this type of maintenance.
MAINTENANCE REQUIRED
1. Check the power cord for any damage.
2. Check sanding belts and discs for damage or wear.
3. Check all guards and hardware to make sure they are secure.
4. Check all moving parts for alignment and binding issues.
4. Dress/Clean sanding surfaces for best abrasive action.
5. Replace sanding belts or discs when worn or damaged.
6. Clean and vacuum dust from the motor housing and other sander parts.
7. Keep iron tables free of rust. Apply coat of paste wax or silicon spray.
NOTE: Lubrication of the bearings is not necessary, as they are sealed and pre-lubricated for life.
Just replace a bearing if failure occurs. Do not use compressed air near bearings. Simply wipe the
exposed bearing surfaces with a dry cloth to clean them.
Service beyond recommended maintenance on these tools should only be performed by an
authorized, qualified technician.
cable should only be done by a qualified electrician.
Plug
Plug

MAINTENANCE

WIRING DIAGRAM

Black
White Main
Switch
This machine must be grounded. Replacement of the power supply
Green
Black
Black
White
Main
Switch
Green
White
Motor
Black
White
Green
Capacitor
Green
18
FREQUENCY
Before each use.
Before each use.
Before each use.
Before each use.
As needed
As needed.
As needed.
As needed.
Capacitor
Motor