BARTINGTON INSTRUMENTS
20.1. Setting Up the Equipment
Place the equipment on a suitable non-magnetic bench with access to a mains electricity supply
but away from potential sources of electrical noise, e.g. large electric motors. Figure 23 shows
the equipment layed out in close formation, from the left: MS2/3 Meter, MS2WF Furnace, MS2W
sensor, MS2WFP Power Supply. .
Figure 23. X/T Equipment .
Plug in the mains supply. Connect the silver shielded cable to the MS2WF, the RS232 connections
to the computer and MS2/3, and the power connections to the water pump and flow meter. The
connections on the MS2WFP are shown in Figure 24 below.
Figure 24. MS2WFP Connections
Page 61 of 82
OM0408/49