List Of Figures - Bartington MS2 Operation Manual

List of figures

Figure 1a. MS2 meter, front panel.
Figure 1b. MS2 meter, rear panel
Figure 2. Replacing the MS2 battery.
Figure 3. Screws in the base of the MS2 meter.
Figure 4. Double-sided insulation foam.
Figure 5. MS2B dual frequency sensor.
Figure 6. MS2C core scanning sensor.
Figure 7. MS2E high resolution surface scanning sensor.
Figure 8. MS2E response characteristics.
Figure 9. MS2E calibration sample: correct orientation
Figure 10. Using a non-magnetic ruler with MS2E sensor.
Figure 11. MS2 probe handle for use with probes type MS2D and MS2F.
Figure 12. MS2D probe.
Figure 13. MS2F probe.
Figure 14. Relative variation in sensitivity around the MS2F probe
Figure 15. MS2G single frequency sensor.
Figure 16. MS2H down-hole probe.
Figure 17. MS2K high stability surface scanning sensor.
Figure 18. MS2K Depth Response.
Figure 19. MS2W water jacketed sensor.
Figure 20. MS2WF furnace sensor.
Figure 21. MS2WFP power supply/temperature controller.
Figure 22. Susceptibility/temperature system.
Figure 23. X/T Equipment
Figure 24. MS2WFP Connections.
Figure 25. MS2WFP outline drawing and mains voltage selection.
Figure 26. MS2WFP Mains Voltage Selector Switch.
Figure 27. Water Supply Connections.
Figure 28. Water cooling system for susceptibility/temperature system.
Figure 29. Setting MS3 to Mode B in Bartsoft.
Figure 30. Mounting the MS2W on the MS2WF.
Figure 31. Using Tweezers to insert crucible into MS2W.
Figure 32. Plug inserted above crucible.
Figure 33. Thermocouple Selection Switch.
Figure 34. MS2WFP Control Panel.
Figure 35. Connection for T type Thermocouple.
Figure A1.1 Magnetic susceptibility of common rocks.
Figure A2.1. Relative response to varying core diameter within MS2C sensor. 77
Figure A2.2. Thin section response of MS2C sensor.
Figure A3.1. Changing the MS2B platen.
BARTINGTON INSTRUMENTS
Page 6 of 82
16
17
20
21
22
24
30
32
33
34
36
37
38
39
40
41
44
49
51
54
55
60
62
63
63
64
65
65
66
67
68
69
69
70
70
72
76
78
79-83
OM0408/49