Installing The Rear Wheel - Yamaha YT175J 1982 Service Manual

WARNING:
Avoid applying too much grease, or it
overflows to the disc plate, thus causing
brake slippage. Therefore, after greas-
ing, install the disc plate, and slide it a
few times, then wipe off the grease on
the disc plate.
4. Install the ring nut and lock washer on
one end of the rear axle and screw in the
ring nut to the specified position.
246.5mm
--(9.65inl
~
5. After screwing in the ring nut, install
another ring nut and lock washer on the
other end of the rear axle, and tighten
the ring nut to specification.
Tightening torque:
135 Nm (13.5m 'kg, 98ft'lb)
6. Tighten the ring nut, which is set in 4.
above, to specification.
Tightening torque:
135 Nm (13.5 m 'kg, 98 ft 'Ib)
7. Bending the lock washers over the ring
nuts on both ends of the rear axle.
NOTE: _ _ _ _ _ _ _ _ _ _ _ _
Always use new lock washers.
8. Tighten the caliper and install the pad
case and chain case.
Tightening torque:
39 Nm (3.9 m 'kg, 28 ft 'Ib)
5-5
9. Adjust the drive chain.
Refer to "Drive chain adjustment" on
page 2-11.
10. Adjust the rear brake.
Refer to "Rear brake adjustment" on
page 2-9.
11. Install the rear wheels.
Rear axle tightening torque:
110Nm (11 m'kg,80ft'lb)
NOTE: _ _ _ _ _ _ _ _ _ _ _
Always use new cotter pins.
Installing the rear wheel
1. To install the rear wheels, reverse the
removal procedures.
Wheel nut tightening torque:
45 Nm (4.5 m . kg, 32.5 ft 'Ib)