Rear Wheel; Removal; Rear Wheel Inspection; Replacing The Wheel Bearings - Yamaha YT175J 1982 Service Manual

REAR WHEEL
Removal
1. Block the front tire and juck up the rear
of the vehicle. Apply the parking brake.
2. Remove the wheel nuts from rear wheel
panel.
1. Wheel nut
3. Remove the rear wheel assembly.
Rear wheel inspection
See
I I
Front wheel inspection" on page 5-1.
Replacing the wheel bearings
1. Block the front tire and juck up the rear
of the vehicle. Apply the parking brake.
5-3
2. Remove the cotter pins from the right
and left rear wheel, loosen the axle nuts
and remove the tires.
1. Cotter pin
2. Axle nut
3. Remove the pad case and chain case.
4. Straighten the lock washer on the right
side and loosen the ring nut, and release
the parking brake.
1. Ring nut 2. Lock washer
5. Loosen the caliper holding nuts and
remove the outer caliper and disc plate.
1. Caliper holding nut 2. Outer caliper
6. Loosen the drive chain.
7. Pull out the rear axle from the rear wheel
by tapping it with a plastic hammer.