Dante Audio Switching Board Numbering Overlays; Applying Dante Asb Overlays To Numbering Plates; Dante Audio Switching Board Overlay Placement - AMX Enova DGX 100 Series Hardware Reference Manual

Dante Audio Switching Board Numbering Overlays

The Enova DGX 6400 can hold up to four Dante Audio Switching Boards (two in the lower input-side expansion board slots
and two in the upper output-side expansion board slots). The Dante ASBs in the top of the enclosure work in conjunction
with the Input Boards; the Dante ASBs in the bottom of the enclosure work in conjunction with the Output Boards.
Overlays are provided to simplify Dante ASB connector wiring on Enova DGX 100 Series enclosures (FIG. 69):
FIG. 69
Dante Audio Switching Board slot numbering overlays on Enova DGX 6400

Applying Dante ASB Overlays to Numbering Plates

1.
Check the labels on the overlay to determine which system it applies to (see table below).
2.
Peel the backing off the overlay and discard the backing.
3.
Align the overlay carefully on the numbering plate then press firmly on the overlay to set the adhesive on the
numbering plate.
4.
Repeat Steps 1 through 3 as necessary for any remaining overlays.

Dante Audio Switching Board Overlay Placement

Enclosure
Enova DGX 800
Enova DGX 1600
Enova DGX 3200
Enova DGX 6400
Enova Digital Media Switchers - Hardware Reference Manual
Audio Switching Board Numbering Overlay Placement
Inputs 9-16, Outputs 9-16
Inputs 17-24, Outputs 17-24
Inputs 33-40, Outputs 33-40
Inputs 65-80, Outputs 65-80
Dante Audio Switching Board
Numbering Overlays
Vertical numbering plate (rear center) - at bottom
Vertical numbering plate (rear center) - at bottom
Horizontal numbering plate (rear top) - at left / right ends
Vertical numbering plate (rear center) - at top / bottom
Dante Audio Switching Boards
156