Fault Finding- General - Stanley Cara Installation And Operating Instructions Manual

ISSUE POSSIBLE CAUSE
Remote Control Batteries Low.
Gas Control Valve Batteries Low.
Optional Mains Adapter not operat-
Remote Control
ing correctly.
not working
Check link between remote &
receiver.
No Gas
Insufficient Gas Pressure
Blocked Pilot Injector.
ON/OFF Switch in OFF (O)
Pilot will not light.
Position.
No Ignition Spark.
Thermocouple & Switch connec-
tions reversed.
Magnet unit not operating properly. Replace Gas Valve.
Short between Interlopers and
Switch cable.
Insufficient Gas Pressure
Resistance in thermocouple circuit
Main Burner will
too high.
not light
Not enough heat on thermocouple. Check position of pilot to thermocouple and intensity
Low voltage from thermocouple.
Short because thermocouple is
damaged or not centreed.
Ignition stops. No reaction to trans-
mitter command.
Main Burner Cuts Too much draft at pilot
out after lighting
FAULT FINDING - GENERAL
SOLUTION
Replace Batteries (See Battery Replacement Section)
Replace Batteries (See Battery Replacement Section)
Check Mains Adapter.
Repair Remote Control (see Pairing Remote Control
Section)
Check Gas Supply.
Check Inlet & Outlet Pressures (see Pressure Check
Section).
Clear debris from Pilot Injector.
Push switch to ON Position (see Figure 26).
Check connection between ignition cable & electrode.
Check electrode spark gap and ensure electrode is
not shorting on burner body.
Replace electrode.
Replace ignition cable.
Check connections to Gas Valve Control Box.
Check connection to Interrupter.
Check Inlet & Outlet Pressures (see Pressure Check
Section).
Check thermocouple cable.
of pilot flame.
Replace thermocouple (Hand tight +1/4 turn max)
Press Reset Button on Gas Valve Control Box.
Check Installation.
30