Manual Mode - Stanley Cara Installation And Operating Instructions Manual

MANUAL MODE

To allow for remote control operation, make sure
that the Manual Knob on the gas valve is in the ON
(Full counterclockwise position) and the ON/OFF
switch is in the I (ON) position - refer to Fig 26.
Press & hold the Power Button, two short beeps are
heard and a blinking series of lines appears on the
remote display (see Fig 27). This indicates that the
start sequence has begun during which the ignitor
will spark until the pilot flame lights. When the pilot
flame has lit and stabilised, the main burner will
ignite & light.
NOTE: If the pilot light does not stay lit
after several attempts, turn the
main valve knob to OFF and
contact
engineer.
When the main burner flame has been established,
the flame height can be adjusted by (refer to Fig 28):
* Increase - Press & Hold the Up Arrow Button.
* Decrease - Press & Hold the Down Arrow
Button.
The flame height can also be adjusted to the two
preset flame heights by:
* Low Fire (LO) - Double Click the Down Arrow
Button - see Fig 29.
* High Fire (HI) - Double Click the Up Arrow
Button - see Fig 30.
To turn off the stove, press & hold the Power Button
until the display shows OFF - see Fig 31.
NOTE: The burner must cool down for 30
seconds before reignition can be
attempted
Fig.26
ON/OFF SWITCH
your local service
MANUAL KNOB
Fig.27
Fig.28
Fig.29
Fig.30
19