Fuel Bed Arrangement - Stanley Cara Installation And Operating Instructions Manual

14. Refit the internal baffle and set up the Fuel
Bed - see Fuel Bed Arrangement Section.
15. Refit the firebox glass panel.
16. Commission the Stove - see Commissioning
the Stove Section.
17. Refit the two front fixing brackets and the
front casting.
18. Refit the bottom heat shield & the fire door.
Fig.14
Locating Tabs
Fig.15
Fig.16
Three Sided Frame
Fit the three sided frame by placing the top section
of the frame over the top hinge point for the door and
engaging the cut-outs on the back of the frame into
the fixing points on the shell (See Fig. 17a).
M4 Fixing Nuts
Inner Spigot
Fixing Points
Outer Spigot
Fixing Bolts
Fig.17
Four Sided Frame
Fit the four sided frame by inserting the frame over
the firedoor and engaging the cut-outs on the back
of the frame into the fixing points on the shell.
Secure in position using the two fixing screws on the
top edge of the frame - see Fig 17b.
Fig.17a
Fig.17b

FUEL BED ARRANGEMENT

NOTE: When arranging the Media into the
Firebed, it is important that the Pilot Area
& the second thermocouple is kept clear
and that no Media enters the Pilot Shield
- see Fig 19.
Fig 18 details the various fuel bed media compo-
nents and they are arranged using the following pro-
cedure:
13
Gas Feed Pipe