First Time Operation; Remote Control Operation - Stanley Cara Installation And Operating Instructions Manual

Before lighting the stove check with the installer that the installation work and commissioning checks described
previously have been carried out correctly. Ensure that all packaging, safety stickers & any protective wrapping
have been removed and that the glass has been cleaned including all fingerprints on the glass. As part of the
stove's commissioning and handover the installer should demonstrate how to operate the stove correctly.
Ensure that the room is adequately ventilated the first time the stove is lit with the windows open. Run the stove
at the maximum setting for a few hours so that the paint gets an opportunity to fully cure. During this period it
is possible for some fumes and vapours to be given off as the paint completes the curement process.
COUNTDOWN
POWER BUTTON
NOTE: If not using the mains adapter, it is recommended that the batteries are replaced in the gas
control box at the beginning of the heating season (see Battery Replacement Section). The
control box will provide frequent beeps for 3 seconds when the batteries are low. A low battery
indicator will be shown on the remote control display when the batteries are low on the remote.

FIRST TIME OPERATION

REMOTE CONTROL OPERATION

TIMER
PROGRAM
BUTTON
REAR BURNER BUTTON
TEMPERATURE
UP ARROW
DOWN ARROW
ECO BUTTON
18
BUTTON