Mounting Procedure - Clearaudio Moving Coil V2 User Manual

User manual / Bedienungsanleitung

1. Mounting Procedure

1. Always handle your cartridge with the protective stylus guard in place.
2. Align the mounting holes of the headshell or tonearm with the holes in the cartridge.
3. Attach tonearm wires to cartridge pins, being careful not to add too much force. Also be sure proper
channel and polarity is maintained.
4. Insert the screws through the headshell holes and engage them to the inner threads of the cartridge body.
Please take care to not overtight them by force.
NOTE: Always try to use Clearaudio cartridge gold clips or damage may result on cartridge pins.
Left output (L+)
+
Left ground
R
L
Right output (R+)
-
Right ground
Pic. 1: Color marking of the signalpins
5. Mount the headshell onto the tonearm (if not intergrated), and adjust the overhang as per tonearm
manufacturer's specifications and tighten cartridge mounting screws fully with the accesssory screwdriver.
Take care that the cartridge is sitting flat and have a full contact to the headshell.
Please read these instructions carefully before attempting to connect or install your MC cartridge to avoid any
loss of warranty. There is a very high possibility of damaging your moving coil cartridge, while connecting or
disconnecting to a preamplifier or phonostage which is not properly grounded.
If the ground of your preamplifier and ground of your tonearm and turntable are not connected together,
there could be a dangerous situation for your MC cartridge (which will be not covered under warranty). Under
such conditions during the procedure of your tonearm first cable connecting to your preamplifier, there could
be a high hum voltage of up to 150 V 150 Hz respectively 80 V 160 Hz present! (Depending on preamplifier-
circuit design!) High current which could flow through your MC cartridge during the plug in procedure could
result in damaging and melting very fine MC Coil gold wires.
This would be not covered by Clearaudio warranty! Therefore, be careful and follow instructions below:
1. Connect tonearm turntable ground with preamplifier ground (before plugging in the
electrical power supply)
2. Mount MC cartridge into the tonearm
3. First plug the tonearm cable into the phono inputs an your preamplifier
4. Preamplifier volume control must be placed fully down (position „ 0 „)
5. Plug the main power cord into your electrical power supply
6. Switch „ ON „your preamplifier
7. Your MC-Cartridge is ready to play!
Keep cool and concentrated when adjusting the cartridge.
Damaged music reproduction or cartridge fault will never reproduce the one we love: music
ATTENTION:
NOT FOR SHELLAC (78RPM) RECORDS SUITABLE!
Made in Germany
>> white
>> blue
>> red
>> green
Page 5