Supermicro SuperServer E300-9D User Manual page 34

SuperServer E300-9D User's Manual
SMBus to PCI-E Slots
Use jumpers JI C1 and JI
2
improve system management for the onboard PCI-E slot.
Manufacturing Mode Select
Close pins 2-3 of jumper JPME2 to bypass SPI flash security and force the system to operate
in the manufacturing mode, which will allow the user to flash the system firmware from a host
server for system setting modifications. Refer to the table below for jumper settings.
VGA Enable/Disable
Use jumper JPG1 to enable the onboard VGA connector. Refer to the table below for jumper
settings.
OCuLink Interface Selection
Use the JNS1 jumper to set the OCuLink port to function as a SATA or NVMe interface.
C2 to enable PCI-E SMB (System Management Bus) support to
2
SMBus to PCI-E Slots
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled (Default)
Manufacturing Mode
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal (Default)
Pins 2-3 Manufacturing Mode
VGA Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
OCuLink Interface Selection
Jumper Settings
Jumper Setting Definition
Pins 1-2 SATA
Pins 2-3 PCI-E
34