Table of Contents
Advertisement
Check the eDrive
Menu 1
Channel Setup
Channel Setup
Channel Setup
Channel Setup
Channel Setup
© 2018 Cutting Edge Optronics, Inc.
WARNING.
Do not set the temperature of SHG below air condensation temperature
(dew point) at laser head. Condensation on the SHG crystal can seriously damage the
crystal.
1. Flip the power switch on the back panel of the eDrive to the ON or - position
2. Make sure that the red EMERGENCY button is released. Turn on the eDrive
by turning the key to ON position and pressing the POWER button to power
up the eDrive.
3. Check all the laser parameters in the eDrive Nitro. The menu designations will
help locate the settings. Use the following values for the Patara laser:
Menu 2
Q-Switch
Q-Switch
Set FPS Settings
Channel 1
Channel 1
Fault Setup
Chapter Four: Installation and Operation
Menu 3
Parameter
Internal Trigger
Q Switch (QS)
Set Frequency
Set Window Width
Set Q-Switch Power
FPS
FPS Mode
FPS Delay
Start Power
FPS Window Length
FPS Modulation Type
PPK Open Offset
PPK Closed Offset
Channel 1
Set Current
Set Standby Current
Set Slew Rate
Slew Control
Set Current Limit
Set Voltage Dropout
Set Current Tolerance
Set Current Tolerance
34
Setting or Value
Enabled
Enabled
refer to test report
5 µs
100%
Enabled
Standard
250 µs
refer to test report
refer to test report
Exponential
0
0
Enabled
refer to test report
0.0 A
5 A/S
Enabled
30 A
20 V
Enabled
4 A
Patara I and II Laser User Manual
Advertisement
Table of Contents
