Advertisement
User Operating Instructions
Note: Two electrical supplies needed.
Economy and 24hr supply.
Connection and Disconnection
Each ECOHHR storage heaters has its own power switch
and is located on the right side panel. The power switch is
used to turn the heater ON and OFF.
If this switch is turned OFF then the storage heater will not
take a charge when the off peak supply is on and will not
give out any heat. Therefore it is important to make sure
this is turned ON at all times.
Each ECOHHR storage heater requires two electrical
supplies. One is an economy tariff supply (off peak or
restricted supply) and the other is a 24hr supply (on peak
or unrestricted supply).
Connection from the economy supply (off peak or restricted
supply) to the heater should be via a 20Amp double pole
isolator switch.
Connection from the 24hr supply (on peak or unrestricted
supply) to the heater should be via a fused double pole
isolator switch or a fused RCD isolator switch, depending
on the installation.
User Control Panel
You will find the keypad on the top right side on the heater.
This easy to use keypad only has four buttons, however
these four button can be use in different ways to give you
many functions and will be explained in more detail in later
sections.
Basic Key functions:
This button is used to set the
temperature. Default is 21°C.
This button is used to set the
temperature. Default is 18°C.
This button is used to decrease values.
This button is used to increase values.
and
Pressing these buttons together will allow
you to set the Day and Time.
and
Pressing these buttons together will allow
you to set the weekly program.
1
'Comfort'
'Economy'
Advertisement
