Encryption Key Exchange Settings Configuration Flow; Specifying Encryption Key Exchange Settings - Ricoh SP 330DN User Manual

Encryption Key Exchange Settings Configuration Flow

This section explains the procedure for specifying encryption key exchange settings.
Machine
1. Set the IPsec settings on Web Image Monitor.
2. Enable IPsec settings.
• After configuring IPsec, you can use "ping" command to check if the connection is established
correctly. Because the response is slow during initial key exchange, it may take some time to
confirm that transmission has been established.
• If you cannot access Web Image Monitor due to IPsec configuration problems, disable IPsec under
[Admin. Tools] on the control panel, and then access Web Image Monitor.
• For details about disabling IPsec using the control panel, see page 73 "Administrator Tools Menu".

Specifying Encryption Key Exchange Settings

• This function is available only when an administrator password is specified.
1. Start the web browser and access the machine by entering its IP address.
2. Click [IPsec Settings].
3. Click the [IPsec Policy List] tab.
4. Select the number of the setting you want to modify in the list, and then click [Change].
5. Modify the IPsec related settings as necessary.
6. Enter the administrator password, and then click [Apply].
7. Click the [IPsec Global Settings] tab, and then select [Active] in [IPsec Function].
8. If necessary, specify [Default Policy], [Broadcast and Multicast Bypass], and [All ICMP
Bypass] also.
9. Enter the administrator password, and then click [Apply].
• An administrator password can be specified in the [Administrator] tab.
1. Set the same IPsec settings as the machine on
PC.
2. Enable IPsec settings.
3. Confirm IPsec transmission.
Transmission Using IPsec
PC
183