When Paper Is Not Fed Or Ejected Properly - Ricoh SP 330DN User Manual

Problem
Fine dot patterns do not print.
If rubbed with your finger, the print
smears.

When Paper Is Not Fed or Ejected Properly

Problem
Prints fall in front of the machine
when they are output.
Prints do not stack properly.
The printed paper is curled.
Printed envelopes come out creased. Check if the fusing unit levers are properly set. Lower the fusing
Only when using PostScript 3
Change the [Dithering] setting in the printer driver's
dialog box.
See the printer driver Help.
The setting of the paper may not be correct. For example,
although thick paper is used, the setting for thick paper may
not be specified.
• Check the paper settings of this printer.
See page 26 "Loading Paper".
• Check the paper settings of the printer driver.
See the printer driver Help.
Raise the stop fence. For the position of the stop fence, see
page 13 "Guide to Components".
The paper being used may be damp. Use paper that has been
stored properly. See page 42 "Supported Paper".
• Load the paper upside down in the paper tray.
• If the paper curl is severe, retrieve prints from the output
tray more frequently.
• The paper being used may be damp. Use paper that has
been stored properly.
• If you enable [Toner Saving] under [System Settings],
printing is generally less dense.
unit levers.
Printer Problems
Solution
Solution
169