Chapter Iv Device Installation; Transport And Storage; Removal - Alpha ESS PWG2-50K User Manual

8 Chapter IV Device Installation

4.1 Transport and storage

Cabinet and module of Bi-directional Hybrid Storage Inverter are packed separately in the packing cases. That is,
multiple modules and a cabinet packed separately in the packing cases. During device transport and storage, pay
attention to the logo on the packing case.
Bi-directional Hybrid Storage Inverter is modularly designed so as to facilitate device positioning and transport. The
selection of storing position should ensure that:
There is no corrosive gas around it.

There are over-wetting and high-temperature sources.

It is not a dusty environment.

It complies with the firefighting requirements.

During transport and storage, three modules can be stacked at most.

The front of module packing case (the side with "Bi-directional Hybrid Storage Inverter" printed) should be placed

upwards. Keep it upright.
During cabinet transport and storage, stacking is not allowed. The device top cannot be placed with other articles.

The cabinet should be placed vertically at forward direction. Don't keep it upright place it horizontally.

4.2

Removal

When removing the module of Bi-directional Hybrid Storage Inverter which is not unpacked from packing case, a
forklift can be used to remove the whole case.
Users can lift the device bottom with a forklift or remove the cabinet of single Bi-directional Hybrid Storage Inverter
through the lifting hole on its top with a crane. It can be transported alone. Refer to Fig. 4-1.
Chapter IV Device Installation
Attention