Table of Contents
Advertisement
Electronic Configuration
Adjustment of the stepper driver current
The stepper driver needs to be adjusted due to that we have changed the previous
motor to a smaller one that requires lower current. There is a risk that the motor
getting overheated and damagaged If we don't do the adjustment.
• You need:
- A Multimeter
- A Sharp tool
• The electronic box is on the left
side of the printer.
• Depending on which cover your
machine has, either use a sharp
tool or a hex wrench to take the
cover of.
• Tip! Grind the tip on the probe to
make it easier to do the
adjustment. Shape the tip like a
small flat screw driver.
Installation manual Bondtech Raise3D V2.0
23
Advertisement
Table of Contents
