Bondtech Raise3D N1 Assembly And Installation Manual page 25

• Touch the red probe to the
potentiometer on the stepper
driver in the top to the left.
Touch the black probe to the
lower screw of the green
terminal.
Now you can see the Vref voltage
of the driver.
• Turn the potentiometer carefully
until you reach the value of
0,5V(500mV), clockwise
increase, counter-clockwise
decrease.
• Repeat this for both
stepperdrivers for the extruders
(if you have a dual printer)
Installation manual Bondtech Raise3D V2.0 24