Bondtech Raise3D N1 Assembly And Installation Manual page 9

• Like this.
• Install the left and right old
screws (2,5mm hex
wrench). Don't tighten the
screws fully.
• Install the 2 rear old
screws (2,5mm hex
wrench). Do not tighten
the screws fully.
Re-tighten the screws in
turns afterwards, (both the
previous on the sides and
the rear ones) carefully to
prevent that the material
crack, DO NOT
OVERTIGHTEN!.
• Cut existing cable ties to
make it possible to re-
arrange the cables.
Installation manual Bondtech Raise3D V2.0 8