Table of Contents
Advertisement
Software Configuration
Changing the E-step value
The E-step value tells the controller how many steps (micro steps) that needs to be
sent to feed 1mm filament. The Raise3D E-step value needs to be updated to
achieve the correct extrusion volume. The reason for this is that the Bondtech Dual
Drive system has a different drive gear diameter and a gearing ratio. The increased
E step value means that the extruder will feed the material with higher precision. This
guide will show how the E-step value can be adjusted directly on the printer.
● The E-step value can easily be
changed on the touch panel
home screen. Click on Utilities.
• Click on the gear for settings in
the top right corner of the display.
Installation manual Bondtech Raise3D V2.0
19
Advertisement
Table of Contents
