• Congratulations! The mechanical
installation is now complete.
Software Configuration
Updating the firmware
We recommend to use printer firmware v0.162 and the lcd firmware V0.161 as the
factory firmware was not allowing setting the z-height after the bed probing was
done. Also it uses a 16 point bedlevelling procedure for better results.
Download the firmware from this link: (Wanhao page)
To update the firmware for the printer use Cura and transfer the new firmware, to
update the firmware on the lcd you must place the files on an Micro SD card, open
up the bottom side of the printer and insert the card into the lcd card reader. This
video
gives a good reference of how to do it, please not use the firmware mentioned
above and not the one on the video as it don't work.
Installation manual Bondtech Wanhao D9 V1.0
11