Related Manuals for Bondtech Wanhao D9 V1.7
Summary of Contents for Bondtech Wanhao D9 V1.7
- Page 1 Wanhao D9 V1.7 Upgrade Kit Assembly and installation manual This work is licensed under a Creative Commons Attribution 4.0 International License.
- Page 2 Table of Contents Introduction Compatibility What’s in the box? Wanhao D9 Upgrade Kit Mechanical Installation What you need Installation manual Bondtech Wanhao D9 Upgrade Kit V1.0...
-
Page 3: What's In The Box
Introduction The Bondtech extruder for Wanhao D9 kit is developed to address the changes made to the original breakout board. As seen in the picture below the old flatcable connector is replaced with a new one. The V1.7 board with a new geometry no long fits the original design of Bondtech Wanhao D9 Extruder. - Page 4 • Start by unloading and remove the filament from your printer. After the filament is removed, power off the printer. ● Disconnecting the flatcable to the printhead and put it out of the Installation manual Bondtech Wanhao D9 Upgrade Kit V1.0...
- Page 5 • And the two screws on the left side. • Remove the break board cover and loosen the connector to the stepper motor carefully. Installation manual Bondtech Wanhao D9 Upgrade Kit V1.0...
- Page 6 2,5mm hex wrench. • Remove the thumbscrew and hinge from the extruder body. • Loosen and remove the 3 M3 screws clamping the motor and extruder together using your 2.5mm hex wrench. Installation manual Bondtech Wanhao D9 Upgrade Kit V1.0...
- Page 7 • Take the new part and carefully assemble the extruder bodies together and make sure the gear shaft is correctly placed inside the bearing. Installation manual Bondtech Wanhao D9 Upgrade Kit V1.0...
- Page 8 • Mount the stepper motor into the extruder rear. • Align the stepper motor and extruder bodies together and insert the two M3x30. Insert the hinge and thumb screw back into its slot. Installation manual Bondtech Wanhao D9 Upgrade Kit V1.0...
- Page 9 • Mount the new breakout board in place by using the two protrusions and snap-fits on the extruder body. Start by aligning the right side of the breakout board into the slot on the extruder body. Installation manual Bondtech Wanhao D9 Upgrade Kit V1.0...
- Page 10 • Slide the new cover over the board, make sure to arrange the cables so it fits into the cut-outs on the left side for the wires to the cooling fans and the hotend. Installation manual Bondtech Wanhao D9 Upgrade Kit V1.0...
- Page 11 Two screws on the right side and two screws on the left side, make sure to support the extruder so it is as parallel as possible to the print bed during tightening. Installation manual Bondtech Wanhao D9 Upgrade Kit V1.0...
- Page 12 If you have any questions, please first read the FAQ (https://www.bondtech.se/en/customer-service/faq/). If the question still hasn’t been answered feel free to contact us by opening a ticket in our support system that you find here Installation manual Bondtech Wanhao D9 Upgrade Kit V1.0...
- Page 13 Repslagarvägen 3 33153 Värnamo Sweden e-mail: support@bondtech.se phone: +46702220193 paypal: payments@bondtech.se web: www.bondtech.se VAT-registration number: SE556995564301 Installation manual Bondtech Wanhao D9 Upgrade Kit V1.0...