Procedures - Frymaster HLZ 18 Service Manual

9.3 Procedures

1. Accessing the interior of the HLZ (Set up for
testing):
a. Disconnect power cord from outlet.
b. Turn unit on its side.
screws located on the bottom of the unit.
c. Then set the unit back down on its base. Place
paper towels on the heater plate to protect it from
scratching. Remove the cowl assembly and lay the
cowl on the heater plate while troubleshooting.
Air heater
relay
Heater Plate
2. Replacing Solid State Relays:
a. Avoid miswiring. Examine the terminals carefully and take notes to avoid miswiring.
b. Remove the plate holding the relay assembly. The nuts holding the relays in place are
easier to reach with the assembly out of the unit.
c. Remove the two nuts holding relays to plate.
d. Apply heat sink compound and install new relay.
e. Reverse this procedure to reinstall.
Frymaster L.L.C., 8700 Line Avenue 71106, P.O. Box 51000, Shreveport, Louisiana 71135-1000
Printed in the United States
Remove the five access
Heater plate
relay
Front of HLZ
318-865-1711
Service Hotline
1-800-24-FRYER
Return to Cover
The cowl assembly is held on by
five screws, which are removed
from the bottom of the unit.
The relays are
best replaced
by removing
the plate that
holds them in
place. Two
5/16 nuts hold
the plate in
place.
FAX 318-862-2394
11
Page