Operation - Frymaster HLZ 18 Service Manual

Display reads SET
Press
program the air heater.
Press the Up and Down Arrow Keys to achieve the desired set-point temperature, then press
the Check Switch once. Both heater LEDs will again light.
Press
to lock the temperature in.
If you are finished with programming both heaters, press the Check Switch again to store the
programmed setpoints and exit the programming mode OR to change the setpoint
temperature for the other heater, press the corresponding Heater Switch (1 or 4).
Program as described in Step 4.
When finished, press
mode. To change the other heater, press
program the heater plate or
heater, then go to Step 4 for instructions.

7.2 Operation

1. Press the ON/OFF switch to the ON position (the display will light and cycle through an
initialization sequence). The display will read –LO- until the air heater and heater plate are
within 15° F of setpoint. It will take approximately 10 minutes for the HLZ to achieve
operating temperature.
Frymaster L.L.C., 8700 Line Avenue 71106, P.O. Box 51000, Shreveport, Louisiana 71135-1000
Printed in the United States
SET,
SET SET
to program the heater plate or
or to get desired setpoint, then press
318-865-1711
1-800-24-FRYER
and LED's light.
again to exit programming
to program the air
FAX 318-862-2394
Service Hotline
to
to
6
Page