Appendix A Prototype Units (Built Before June 15, 1998) - Frymaster HLZ 18 Service Manual

APPENDIX A – PROTOTYPE UNITS (built before June 15, 1998)
A.1 Parts List For Prototype Units
A small quantity of units were manufactured before June 1998. The following is a list of
replaceable parts for those units which are not in common with later production models:
HPLA 12 (On/Off Switch)
Part Description
Number
807-2082 On/Off Switch
807-2512 Resistor 50W 100 ohm *
807-2954 Blower, 115V *
807-2278 Fuse, 20A
807-2447 Fuse Holder
812-1346 Cordset
806-8988 Controller, HPLA
807-2323 UHC Heater Plate, 18"
807-1568 Air RTD Probe
HPLA 12 (Computer)
Part Description
Number
806-9155 Cowl Assembly
807-3002 Plate, Heater 12"
910-8138 Bumper, HPLA 18 Burger
806-9198 Computer Assembly, HLA
807-0067 Terminal Block (8-pin)
807-3020 Cordset
Frymaster L.L.C., 8700 Line Avenue 71106, P.O. Box 51000, Shreveport, Louisiana 71135-1000
Printed in the United States
Part
Number
807-2278
807-3020
812-1346
807-2512
807-2954
806-8988
807-3005
807-2880
806-9239
806-9253
807-0067
806-9198
806-9155
318-865-1711 FAX 318-862-2394
Service Hotline
1-800-24-FRYER
Return to Cover
HPLA 18
Description
Fuse, 20A
Cordset, HLZ
Cordset
Resistor, 50W 100 ohm *
Blower, HPLA 115V *
Controller, HPLA
Plate Heater, 18" HPLA24
UHC Plate Heater 18"
Plate Heater, 12" * *
Bumper, Burger
Terminal Block (8-pin)
Computer, HLA
Cowl Assembly
* Replace these components with PN
807-2953, Blower
Remove resistor assembly as it is no
longer needed if a 208V Blower is
used.
** Correct resistance for this Plate
Heater is 230 (±15) ohms.
208/240V.
23
Page