Table of Contents
Advertisement
Final Connection
Treadmill to DT7 Desk Assembly
A. Position the pre-assembled treadmill as shown below.
B.
Lift the rear of the treadmill and roll it forward under the desk until the
Treadmill Locator Cap(D) located on the treadmill are centered over the
Locator Knob(A) at the base of the uprights.
Roll Forward
Lift
NOTE:
Desk D-Connector
9 Pin
Data Cable
C. Connect the 9 Pin Data Cable(21) into the
desk D-Connector on the Right Base Foot(7) and treadmill Console Port
and tighten the thumb screws.
D. Plug the Power Cord into the treadmill Power Receptacle on the Left Base
Foot(6) and wall outlet.
F.
Turn the treadmill Power Switch on.
36
D
Depending on the width of the Desk and position of the
Treadmill Base the locator cap may or may not be used
Treadmill Connections - Rear View
7
21
Be sure all connectors
are plugged in prior to
connecting the power cord
Power Switch
Power Receptacle
Console Port
D
A
NOTE:
Hide quick links:
Advertisement
Table of Contents
