LifeSpan TR1200-DT7 Owner's Manual page 23

Step 4: Attach Reinforcement Frame
Contents: 8 each M8x35L Bolts with Washers, 6 each M6x15L Screws.
A. Locate the Front Reinforcement Frame labelled (1) and the Back
Reinforcement Frame labeled (2). Place these frames on Desktop with
screw tabs down and facing each other as shown in figure below.
B. Extend Front and Back Reinforcement Frames(1, 2) to align all mounting
holes with Desktop(3) and Motorized Legs(4, 5).
C. Loosely install the eight M8x35L(15) bolts through the Reinforcement
Frames (1,2) and into the Motorized Legs (4,5).
D. Tighten all eight M8x35L(16) bolts.
E. Using the six M6x15L Screws(17) attach both Reinforcement Frames to the
Desktop as shown in the illustration.
Tighten the pre-installed Set Screws(A) . Be careful not to overtighten as
F.
the tube will bend.
NOTE:
72" desktop shown for clarity of frame
components. When mounting the frame
to smaller desktop sizes, the front and
back reinforcement frame pieces slide and
compress into shorter lengths.
16
4
LOCATE BAG LABELED STEP 4
Center Positions
17
2
16
17
17
A
1
A
3
5mm Allen M8x35L Screw
Wrench w/
(x8)
Phillips
Desk Assembly
16
5
Front
M6x15L Screw
(x6)
16
4mm
27