Zoom H4n Pro Operation Manual page 139

MTR mode effect types and parameters
■ EFX modules
● Compressor/limiter effects
Compressors reduce high-level signals and raise the
RackComp
minimum level.
(1) THRSHOLD 0–50
(2) RATIO 1–10
(3) ATTACK 1–10
(4) LEVEL 2–100
Limiters compress when input signals exceed the fixed
LIMITER
level.
0–50
(1) THRSHOLD
1–10
(2) RATIO
(3) RELEASE 1–10
(4) LEVEL 2–100
143
Sets the base level from which the compressor
operates.
Sets the compression ratio.
Sets how quickly compression starts.
Sets the level of the signal after the EFX module.
This sets the base level from which the limiter
operates.
Sets the compression ratio.
Sets how quickly the limiter stops functioning
after the signal goes below the base level.
Sets the level of the signal after the EFX module.
● Modulation effects
This wah effect responds to changes in input signal
AUTO WAH
strength.
Before,
(1) POSITION
After
−10–−1,
(2) SENSE
1–10
(3) RESONANC 0–10
(4) LEVEL 2–100
This effect varies the sound with phasing.
PHASER
Before,
(1) POSITION
After
0–50, ♪
(2) RATE
(See P.146)
4STAGE,
8STAGE,
(3) COLOR
INVERT4,
INVERT8
(4) LEVEL 2–100
TREMOLO This effect raises and lowers the volume cyclically.
(1) DEPTH 0–50
0–50, ♪
(2) RATE
(See P.146)
UP 0–9
DOWN 0–9
(3) WAVE
TRI 0–9
(4) LEVEL 2–100
Sets the insertion point of the EFX module.
Select before or after the PREAMP.
Sets the effect sensitivity.
Sets the amount of resonance.
Sets the level of the signal after the EFX module.
Sets the insertion point of the EFX module.
Select before or after the PREAMP.
Adjusts the speed of modulation.
Select the effect sound type.
Sets the level of the signal after the EFX module.
Adjusts the modulation depth.
Adjusts the speed of modulation.
Select the modulation waveform from UP (rising
sawtooth), DOWN (falling sawtooth) and TRI
(triangle) types.
The higher the number, the more the wave peaks
are clipped, emphasizing the effect.
Sets the level of the signal after the EFX module.