Table of Contents
Advertisement
14
266CRH / 266CRT, 266CSH / 266CST MULTIVARIABLE PRESSURE TRANSMITTER | OI/266CXX/MODBUS-EN REV. A
... 4 Product identification
... Name plate
The device is identified via the signs (plates) presented in
Figure 3.
Rating plate
A
The rating plate provides information including the model
number, maximum working pressure, range and span limits,
power supply, output signal, diaphragm material, filling fluid,
serial number, maximum permissible operating pressure (PS),
and maximum permissible temperature (TS). Please specify the
serial number when submitting inquiries to the ABB customer
service department.
The device can be used as a pressure accessory (category III) as
defined by the Pressure Equipment Directive 2014/68/EU. In this
case, you will find the number of the notified body that has
verified compliance next to the CE mark.
CE identification number of the notified body for the Pressure
Equipment Directive: 0045.
Certification plate
B
The certification plate is on the transmitter and indicates
whether the device is designed for general use or for use in
hazardous areas.
The certification plate shown has been issued for ABBAPR, 32425
Minden, Germany with the following numbers:
FM09AATEX0023X or IECEx FME 16.0002X (Ex d)
FM09AATEX0025X or IECEx FME 16.0004X (Ex n)
CE identification number of the notified body for ATEX approval:
0044.
Note
•
For ambient temperatures 40 to 85 °C ( 40 to 185 °F) the
information based on the temperature classes in the
associated certificates, must be complied with.
•
The temperature sensor circuit (Pt100) and the digital output
(pulse / limit value output) must be connected in accordance
with the requirements of the Ex certificate.
Additional plate
C
An additional plate specifies the measuring point number of the
customer and the calibration range.
Marking according to Pressure Equipment
Directive
Devices with PS > 200 bar (20 MPa)
Devices with a permissible pressure of PS > 200 bar (20 MPa)
have been tested for conformity by the Technical Supervisory
Association TÜV NORD (0045) in accordance with module H and
can be used for liquids of group 1 (PED: 1G).
The name plate contains the following designations: PED: 1G.
Devices with PS
200 bar (20 MPa)
Devices with a permissible pressure PS
conform to sec. 3 para. (3) and have not been tested for
conformity. The devices have been constructed and
manufactured according to sound engineering practice (SEP).
The CE mark on the device does not apply for the Pressure
Equipment Directive.
The name plate then contains the following identification codes:
PED: SEP.
Scope of delivery
•
Multivariable transmitter model 266Cxx.
•
This operating instruction, calibration protocol, and possibly
optionally requested certificates in an envelope.
•
Hexagon socket wrench for unscrewing the fastening screws
of the housing.
•
Additional parts as specified in the purchase order:
-
½ in-NPT-f adapter with appropriate seals
-
Fastening accessories
-
Accessories for the electrical connection
200 bar (20 MPa)
Advertisement
Table of Contents
