Connecting The Device; Connecting To The Power Supply; Connecting To A Computer Or Computer Network; Switching On The Device - Brady A8500 Assembly Instructions Manual

5 Installation
5.3

Connecting the Device

5.3.1

Connecting to the Power Supply

The printer is equipped with a wide area power unit. The device can be operated with a supply voltage of
230 V~/50 Hz or 115 V~/60 Hz without adjustment.
1. Check that the device is switched off.
2. Plug the power cable into the power connection socket (25 / Figure 5).
3. Plug the power cable into a grounded socket.
5.3.2

Connecting to a Computer or Computer Network

!
Attention!
Inadequate or no grounding can cause malfunctions during operations.
Ensure that all computers and cables connected to the printer are grounded.
 Connect the printer to a computer or network by a suitable cable.
For details of the configuration of the other interfaces  Configuration Manual.
5.4

Switching on the Device

When all connections have been made:
 Switch the printer on at the power switch (24 / Figure 5).
The printer performs a system test, and then shows the system status Ready on the display (24 / Figure 4).
User Manual
13