Table of Contents
Advertisement
Maintenance
15
The MotorController and ventilation system should be checked, serviced and, if necessary, repaired at least once per year by
the manufacturer or an authorized partner
Remove all soiling from the units of the ventilation system. Check fastening and clamping screws for firm seating.
Carry out a test run of the entire system (see chapter 14 'Commissioning and test run).
Only have defective units repaired in our factory. Only install original spare parts.
Check the operational condition at regular intervals. We recommend a WindowMaster service contract is taken out to ensure the
right function of the ventilation system.
We recommend that the software of the MotorController is updated the annual maintenance check!
The expected minimum lifetime for the MotorController is 10 years.
15.1
Maintenance agreements
WindowMaster offer maintenance agreements for the ventilation system. Contact our service department for further information:
telephone +44 1536 510990 or info@windowmaster.co.uk
15.2
Replacement 3M4, 3M8 and 3KI card
1. Disconnect the 230 V
2. Remove the old card
3. Insert the replacement card.
4. Turn on the 230 V.
5. The system will be ready again after approx. 2 seconds.
Declaration of Conformity
16
The MotorController is manufactured and tested accordingly to the European requirements.
The total system is not to be put into service until a declaration of conformity for the total system has been made.
The "Declaration of Conformity" is supplied with the MotorController as separate documents.
19
Advertisement
Table of Contents
