Electric Connections; Connecting The Power Plug; Connecting The Multiple Switch; Connecting The Ebus Connector - Brink Renovent Excellent 180 Installation Instructions Manual

5.5

Electric connections

5.5.1 Connecting the power plug

The appliance can be connected to an easily accessible,
earthed wall socket with the plug that is mounted to the ap-
pliance. The electric installation must comply with the require-
ments of your power company.
Make allowance for a 1000 W preheater/postheater that
may optionally be connected.

5.5.2 Connecting the multiple switch

The multiple switch (not supplied with the appliance) is con-
nected to the modular connector type RJ12 (connected to X2
on the control board) that is placed at the top of the appliance.
Dependent on the type of multiple switch that is used, a plug
RJ11 or RJ12 can be connected to it.
cases requires an RJ12 plug in combination with a 6-core
modular cable.
cases requires an RJ11 plug in combination with a 4-core
modular cable.
Refer to diagrams §11.2.1 to §11.2.4 for connection examples
multiple switch.
Other options include wireless remote control or a combination
of multiple switches.

5.5.3 Connecting the eBus connector

The Renovent Excellent uses the eBus protocol. The 2-pole -
detachable - screw connector for the eBus connection is at the
top of the appliance.
The eBus protocol may for instance be used to connect (the
cascade control of) appliances (see §11.3). Because of polarity
sensitivity, always connect contacts X1-1 to X1-1 and contacts
X1-2 to X1-2; the appliance will not work when these contacts
are interchanged!
Chapter 5
The optionally available Brink Air control must
be connected to these eBus connector.
A
Cables to be connected by installer
(wire diameter at least 0,34 mm
nr.2
nr.1
Renovent Excellent 180
Installation
Warning
The fans and control board carry a high volt-
age. Always take the voltage from the appli-
ance by pulling the power plug when working
on the appliance.
The 4-way switch can also be used to activate a 30-minutes
boost mode by putting the switch to setting 3 for less than 2
seconds and directly turning it back to setting 1 or 2. The boost
mode can be reset by putting the switch to setting 3 for longer
than 2 seconds or by switching it to absence mode (
modular connector
2-pole eBus connector
2
)
A
Rev. E
).
11