Advertisement
HoldT
-
1 x Press: Data Transfer [rS232] to PC
(PC) or to the printer (Print) or (in version U
5.1) to the test stand (stand)
rS232
- PC: Pressing SET once: Saves the Settings
- PRINT: Pressing SET twice: sending data to the printer
- STAND: Pressing SET three times: sending a signal to
the Test Stand to stop its movement (in version U 5.1)
Back Light:
PEAK:
Three functions
-
Track mode (continuous measurement)
-
Peak mode (capture of maximum values)
-
Auto-Peak mode, same as Peak-mode, only
without the „Min limit peak save" function
MEMORY:
Saves the peak values to calculate the average
value (please see section "Memory mode"
DELETE Function
Deletes stored peak values (only in „Memory
mode" active)
PRINT:
Sends the stored peak values to a PC or Printer
(please see section „Data Output")
High / Low limit function
LEDs to display OK / NOT OK Tests
▼
Lower than lower limit
OK
OK
▲
Higher than higher limit
This function allows efficient testing of OK / NOT OK
measurements of similar or identical testing objects.
A lower and an upper limit value can be defined. The
instrument compares the individual measuring results with
these limit values and shows the OK or NOT OK result by
green or red light diode and by sound.
FH_SO-BA-e-1217
Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: info@kern-sohn.com
Instruction Manual
FH
To set these limit values, please see the SET Menu in
section „Operating keys".
Measurement (Track Modus)
Display (1) shows the continuous force in a defined
direction (6)
To zero the display, press:
Peak-Hold Function (Peak Mode)
Please press:
Auto-Peak-Hold-Function(Auto-Peak Mode)
Please press:
Min. limit peak save
This function allows to eliminate unwanted „Pre-Peak
values" that are lower than the main peak value (Fp). The
"Min limit peak save" value (Fo) takes care, that these
"Pre-Peak values" are not saved.
The „Min limit peak save" function is only possible in
Peak-Mode.
To set this Min limit value, please see the SET Menu in
section „Operating keys".
Memory mode and average value (from up to 10 peak
values)
Saving peak values in the instrument
Tel: +49-[0]7433- 9933-0
Fax: +49-[0]7433-9933-149
Internet: www. kern-sohn.com
Activating the „AUTO PEAK Function" by PEAK key
Deactivating the „Average Function" by MEMORY
key
Now, all peak values are stored automatically in the
instrument
3
Advertisement
