KAT VR WALK User Manual page 53

53 Starting Installation
Unable to Walk or Walk Slowly in the Game
Cause: The DLL files are not installed
Solution: Contact the KAT service center to obtain the DLL files and put them under the system32 directory in the C
drive.
Cause: Incorrect connection of KATVR-Foot Sensor
Solution: If the working indicator on the KATVR-Foot Sensor is red, check if its six-digit dialer value is consistent with
that of the wireless receiver. If not, please re-dial the dialer.
Cause: Inconsistent dialing values of the two KATVR-Foot Sensor
Solution: Turn off the two KATVR-Foot Sensors, and make the values of the two KATVR-Foot Sensors consistent with that
of the wireless receiver.
Cause: KATVR-Foot Sensor error
Solution: If the re-dial does not work, then there is an error with the KATVR-Foot Sensor which may need to be replaced
with a new one.
Cause: The static value is not set; improper operations in the settings of the static value
Solution: Re-set the static value by following the steps on page 37 of the User Manual. Make sure the player stands
upright on the KAT WALK when setting up the static value. If the player is thin, ask him to slightly lean back.
Cause: The player did not stand upright on the KAT WALK as instructed in the settings of the
static value
Solution: Re-set the static value by following the steps on page 37 of the User Manual. Make sure the player stands
upright on the KAT WALK when setting up the static value. If the player is skinny, ask him to slightly lean back.
Cause: Inconsistent values of the KATVR-Central and the KATVR-Back Sensor or multiple
equipment with the same dialing value in the same place
Solution: Check if the dialing value of the KATVR-Central is consistent with that of the KATVR-Back Sensor. Make them
consistent if not and note the position of the ON on the dialer when dialing it.
(If there is more than one KAT WALK within the same room, check if their values are the same. If so, please dial the
dialers to make the values different.)