KAT VR WALK User Manual page 15

1５ Starting Installation
13. As shown in the figure, install the shell at the girder tail, put the three-in-one cable and the KATVR-Encoder cable
through the shell and tighten them with the R-shaped clips.
Orientation of the
girder head
Orientation of the
support pillar tail
14. The installation personnel erect the support pillar and one male adult should hold it to prevent it from toppling,
while the others install the set screws and make sure they are tightened.
The installation personnel erect
the support pillar and prevent it
from toppling, while the others
fasten the screws.
Pierce
Piercing
Plastic shell 2 at the girder tail
Plastic shell 1 at the girder tail
st3.5 screw
Spring washer
M10 screw
Flat washer