KAT VR WALK User Manual page 17

１ ７Starting Installation
17. Install the connecting rod. One person stands below the telescopic stick and pull the stick to the bottom, one person
directs the connecting rod at the hole on the connecting panel of the telescopic stick, and another person installs the bolt
to fix the connecting rod.
18. Install the equipment storage hook. Unscrew the screw off the connecting rod, put it through the installation hole on
the equipment storage hook and fix it onto the connecting rod.
19. Loosen the base plate holder, move the KAT WALK to an appropriate position, re-fix the holder to prevent the KAT WALK
from sliding, and finish the installation.
20. Installing the pedals: As the upper surface of the KAT WALK base plate is concave and to enable users to better use our
equipment, pedals that perfectly match the base plate are added under the support of the railings on the upper end of the
girder. There is no need to install the pedals, which can be matched directly with the base plate. They are fixed onto the
plate through their own weight with no connection between them and the plate.
M10 screw + spring washer + flat washer
背杆传感器
专用供电线
KATVR-Relay
dedicated power
supply cable
Unscrew this screw to
install the equipment
storage hook