KAT VR WALK User Manual page 16

１ ６ Starting Installation
15. Installing the ground plug: as shown in the figure, install the grounding plug onto the support pillar and tighten the
screws. Note: The screws have been installed onto the support pillar upon delivery and the grounding plug is included
in the accessory box.
16. Installing the support pillar bottom shell: slot the support pillar bottom plastic shell 1 into the pillar and adjust it to
the appropriate position. Install the pillar bottom plastic shells as shown in figure 3.1.3 and use the st3.5 screw to
tighten. Lock the st3.5 screw when fine adjusting it to the position shown in figure 3.1.4.
Bottom plastic shell 2
Bottom plastic shell 1
Figure 3.1.3
Support pillar
st3.5 screw
Bottom plastic shell
Base plate
Figure 3.1.4