Power Switch - KAT VR WALK User Manual

27 Starting Installation

Power Switch

Upon confirming the proper installation and connection of the product, press the power
button for all the devices
a. Check if the handles are fully charged. You may check the control handle battery charge level when not running any
program or upon opening the main control panel of the system. When the battery charge level is insufficient, the
indicator will display a red dot. Use the accessory power adapter and the USB data cable to charge each control handle.
When the handles are powered on and fully charged, the status indicator will display green color (powered on) or white
color (powered off).
b. Connecting base station to power
The base station needs continuous power supply when being used and it is advised to install a power socket near the
station.
c. Power supply to KATVR-Back Sensor
1. Power for the KATVR-Back Sensor is supplied through the USB dedicated power supply cable tied to the back of
the connecting rod. Supply power to the head-mounted display before the use.
2. The power for the KATVR-Back Sensor is supplied by the portable power bank. Fix the power bank to the
connecting rod and connect the power bank to the KATVR-Back Sensor with the KAT dedicated power cable. Make sure
the power bank has sufficient power before the use.
d. The PC is Powered on
Caution
The sensors require continuous and extremely low constant current for their operation, and the
traditional portable power banks in the market cannot meet the requirement, please use the
KAT dedicated and independent power bank set to ensure the proper operation of the sensors.