KAT VR WALK User Manual page 13

13 Starting Installation
8. One person holds the support pillar, while two other persons turn the girder so that it rotates from a lying position
(position 1) to a 90° angle (position 2). Place the bolt at the connection between the girder and the support pillar in the
washer and fasten it.
Position 2
Orientation of the
support pillar
bottom
Support pillar
9. As shown in the figure, insert the telescopic stick into the round hole at the front of the equipment, and slot the spring
pallet and the spring into the stick; then screw the safety nut onto the stick and the M5 set screws (two) to the side of
the stick; screw the round nut into the stick, and use the hook spanner to tighten it; finally slot the nylon nut into the
upper end of the stick and tighten it.
Nylon lock nut
Safety nut
Spring pallet
Telescopic stick
Position 2
Round nut
Spring
Spring