Instructions For Base Plate Holder; Caution - KAT VR WALK User Manual

18 Starting Installation
Instructions for the Base Plate Holder
There is an upper nut and a lower nut on the base plate holder, with the lower one adjusting the holder, while the upper
one fixing it. Please do tighten the two nuts when fixing the KAT WALK.
1. When moving the KAT WALK, turn the upper nut on the base plate holder clockwise to move the nut down,
and turn the lower nut counter clockwise to move the nut up. With the base plate holder shortened, the KAT
WALK can be moved.
2. When fixing the KAT WALK, turn the lower nut on the base plate holder clockwise to move the nut down,
and turn the lower nut counter clockwise to move the nut up.

Caution

1. The proper and steady installation of the support pillar structure allows the user to have a good experience,
and thus, please check if the support pillar is correctly and steadily installed.
2. During the installation, avoid putting any items on the base plate and do not randomly step on the base
plate in case of any damage to it, which spoils users' experience.
3. After the installation, check if all the bolts and nuts are fastened.
4. Please turn off the power and make sure all the circuits are power off to avoid potential risks before
installing the circuits.
5. As the length of the three-in-one cable for the head-mounted display is limited, please watch out for the
length of the remaining cable when connecting the circuit on the girder.
6. As there are quite many circuits, please differentiate the connection at all the interfaces.
7. If a bolt is not fully concentric with its hole during the installation, please slightly turn the component to
make them concentric.