KAT VR WALK User Manual page 14

14 Starting Installation
10. As shown in the figure, use the M5 screw to fix the cable at the corresponding position at the girder head (note: the
top cable hole faces the front).
11. Unscrew the screw on the top cover off the shell. Install the top cover to the front end of the girder and use the
unscrewed screw to fasten it, as shown in the figure.
12. Put in the three-in-one cable (the red dotted line in the figure) from the lower end of the telescopic stick and pull it
out from the upper end. Put the sticking three-in-one cable and the KATVR-Top Sensor cable through the girder and
fasten them with the R-shaped clips (the two clips on the girder have been installed to the square tube).
Reserved cable
length of 90-100cm
Caution
The product accessory clips are used to tighten the three-in-one cable and the
KATVR-Encoder cable and users need to tighten them on their own.
Red - three-in-one cable bundle
Blue - KATVR-Top
Sensor cable bundle