Programming The Instruction Message - 1835 Only 37 3.4.3 - DoorKing 1837 Owner's Manual

3.4.3 Programming the Instruction Message – 1835 ONLY
The instruction message scrolls across the screen from right to left when the system is not in use and
follows the user message programmed in 3.4.2. The instruction message can be a maximum of 52
characters (spaces count as a character) and is entered into the system memory in three blocks. The
first two blocks contain 20 characters while the third block contains 12 characters. The example below
shows how the sample instruction message was divided into three blocks and programmed into the
system. Use the blank table to organize your own message. Only upper case letters, numbers and spaces
can be programmed from the system keypad.
Factory Default Instruction Message: Push A-Z To Find Name Or No. Enter Code Or Push Call
Example: PUSH A OR Z BUTTON TO FIND NAME ENTER CODE OR PUSH CALL
1 2
Block 1 P U
Block 2 N A
Block 3 U S
Note: The factory default message was programmed from a PC, therefore upper and lower case letters are displayed.
1 2
Block 1
Block 2
Block 3
After organizing the instruction message in the table above, follow the instructions below to enter the message into the system.
After each desired letter, number or space is displayed on the directory, remember to press
count as a character and must be entered into memory as a character. After a complete block of characters (including spaces)
has been entered, press
8 1
1. Press
The LCD display will read: BLOCK 1.
2. Enter the characters into block 1 (refer to 3.4.1 for reference). Remember to press
3. After the last character in block 1 has been entered, press
The LCD display will read: BLOCK 2.
4. Enter the characters into block 2. Remember to press
5. After the last character in block 2 has been entered, press
The LCD display will read: BLOCK 3.
6. Enter the characters into block 3. Remember to press
7. After the last character in block 3 has been entered, press
8. Press (beep) to enter all three blocks into the system memory.
9. Press 0 together to end this programming sequence (beeeeeep).
10. The new instruction message will begin to scroll across the screen.
1835-067-A-9-18
3 4 5 6 7
S H A
M E E N
H C A L
3 4 5 6 7
to enter the block, then start the next block.
*
and enter your four-digit MASTER CODE
8 9 10 11 12
O R Z
T E R C
L
8 9 10 11 12
? ? ? ?
(beep) to enter the entire block.
(beep) after each character.
(beep) to enter the entire block.
(beep) after each character.
(beep) to enter the entire block.
13 14 15 16 17
T O F I
O D E O
13 14 15 16 17
to enter that character. Spaces
*
(beep).
(beep) after each character.
A
1 2 3
4 5 6
Z
7 8 9
0
CALL
18 19 20
N D
R P
18 19 20
37