Install Enclosure - DoorKing 1837 Owner's Manual

1.4 Install Enclosure

The illustrations below and next page show typical installations but specific
installations can vary from this. See previous page for dimensions.
1. Mount the enclosure using the mounting holes provided in the
corners (see next page for OPTIONAL flush mount kit OR hood
dimensions). Be sure that mounting screws (Not supplied) do not
protrude into the enclosure where they could cause a short on the
back of the circuit board. Make any necessary conduit connections
through the back or bottom of the enclosure using the existing
conduit knock-outs. DO NOT make any new conduit holes in the
enclosure.
2. Route all wiring through conduit or architectural post (not
supplied) into enclosure.
3. Clean out the enclosure. Make sure that all dirt, metal and/or
wood debris is removed.
4. Re-install components back into the enclosure (Reverse section
1.2 steps). Use the wiring schematics in the back of this manual to
help re-install the components if necessary. DO NOT apply any
power at this time.
Mount to a DKS
Architectural
Post
L
N A
T I O
O P
o d
H o
Use hardware supplied with
architectural post to secure
enclosure to post.
Mount OPTIONAL
Hood
The hood (sold separately) fits
between the enclosure and the
surface it's being mounted on if
desired.
Note: The hood CANNOT be
used with the flush mount kit.
Run all wires
inside post.
8
M o
u n
t i n
g H
E n o l e
c l o
s u r
Examples of conduit runs that may be used, depending on how you choose to run
e
the wiring. Some installations will allow the conduit to be run outside the wall and
connect to the bottom of the enclosure but this is generally NOT recommended.
K n
o c k
- o u
t
Mount
(OPTIONAL Flush Mount Kit Required).
W a
l l
Continued on next page.
Mount
W a
l l
Use appropriate
hardware to secure
enclosure to the wall
(not supplied).
Conduit run
Conduit
to junction box
sweep run
IN
a Surface
T r i m
R i n
g
M o
u n
t i n
( N o
g S
t s u
c r e
w s
p p
l i e d
)
R o
u g
h - I
n
B o
x
Mount OPTIONAL
Flush Mount Kit
Mount the rough-in box in the wall and trim
ring will fit inside of rough-in box.
Note: The hood CANNOT be used with the
flush mount kit.
ON
a Surface
M o
u n
t i n
g S
c r e
w s
( N o
t s u
M o
p p
u n
t i n
g H
o l e
E n
c l o
s u r
e
K n
o c k
- o u
t s
L o
c k n
u t
E n
c l o
s u r
e
K n
o c k
- o u
t s
1835-067-A-9-18
l i e d
)